Home > News > Common problem
1-1:不带操作台安装流程 1、拆包装,装接货架:安装前先将包装拆除,将接货架取下对接传送台出口安装(备注:出口有“警报灯”标识) 2、连接显示器、鼠标键盘:将键盘鼠标插入USB延长线接口,电源线和VGA线插入...
More+1、图像处理功能介绍 机器型号分为 5030,6550,8065,10080,100100。如在机器的面板上印着F6550,就是机器的型号。现在介绍软件各按钮的作用。如图: 指示灯:开机后连接和采集灯是常亮的,校准后X光灯会亮...
More+Security machine operation 1. Remove debris from the conveyor belt of X-ray machine. 2. Check the entrance of the passage and the red emergency stop button on the operation platform should rotate clockwise and ...
More+1. Power distribution board 2,电源 3,主机 4,光源 5,电滚筒 6,滚筒控制器和48V电源 (小机专用) 7,分配器 (大机专用) 8,滤波器和继电器 (大机专用) 9,电容 (大机专用...
More+1: After power on, the power indicator lights up and then turns off. A: The emergency stop is not in a bouncing state, and it will bounce when rotated ninety degrees clockwise. B: Poor contact at the main power...
More+一 打开安检机的侧边门板(最中间的那块),查看设备上面的工控机有没有启动。(启动会亮灯)如下图: 亮灯属于正常启动状态。 二 打开操作台的后盖,在底部上会看见连接三根信号输入线的设备,检查设备上的电...
More+